Contrex MLP-Trim Bedienungsanleitung PDF herunterladen (Seite 180)

C - 12

MP-59 FREQUENCY OVER FLOW COUNTER

The Frequency Over Flow Counter (MP-59) is a counter that increments each time the frequency

input to the MLP–Trim causes an overflow. To reset the counter to “0”, press the Clear key.

CP-60 OPEN LOOP

If CP-60 is set to "1", then the J6 Pin 12 input acts as the Scroll Down input. If CP-60 is set to

"2", then this input is the Open/Closed Loop input.

CP-61 DIRECT ENABLE

In the Direct mode of operation, the Speed Command output from the MLP–Trim that is

connected to the motor drive can be set directly. Direct mode is an open-loop mode of

operation. Use Direct Enable (CP-61) to either enable or disable the Direct mode.

Enter "1" to enable the Direct Mode.

Enter “0” to disable the Direct Mode.

Enabled

Code

CP-62 INVERSE SCALING

Use Inverse Scaling (CP-61) to select either the Standard or the Inverse setpoint scaling format.

Enter “2” for Inverse Scaling.

Enter "1" for Standard Scaling.

Inverse Scaling

Code

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 215 216

Keine Kommentare

Contrex MLP-Trim Bedienungsanleitung Seite 180