Contrex ML-TRIM Bedienungsanleitung PDF herunterladen (Seite 94)

3 - 60

Table 3-32 Control Command Send - ML–Trim Response

Character # 1 2 3 4 5 6 7 8 9 10 11 12

DEV # DEV # ERROR PAR # PAR # DATA DATA DATA DATA DATA

DESC STX 10s 1s CODE 10s 1s 1000s 100s 10s 1s FORM ETX

ASCII STX 0-9 0-9 @-DEL 0 0 0 0 0-9 0-9 0 ETX

The following is a description of the Control Command Send-ML–Trim Response

Characters.

Character 1 - STX:

This is the first character in the character string.

Characters 2, 3 - Device #:

This is the two character access address for the ML–Trim.

Character 4 - Error Code:

If there are errors in the transmission that the ML–Trim receives from the host

computer, the Error Code will display them. Use Table 3-35 (page 3-66) to convert

the ASCII code to binary. The binary code can be decoded as follows:

Bit 7 Always “0”.

Bit 6 Always “1”.

Bit 5 1 = Data was out of minimum/maximum range.

Bit 4 1 = Checksum or Decimal Point Error, Invalid Parameter Code.

Bit 3 1 = Receive buffer filled before “ETX” received or Message Format Error.

Bit 2 1 = Invalid Parameter Data.

Bit 1 1 = Parity Error.

Bit 0 1 = Always “0”

Note: The ML–Trim will only accept data if there are no errors. The ASCII

error code “@” (Binary code “1000000”) indicates that the Host Transmission

contains no errors.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 179 180

Keine Kommentare

Contrex ML-TRIM Bedienungsanleitung Seite 94