Contrex CX-1102 Bedienungsanleitung PDF herunterladen (Seite 16)

Page 14

The CX-1102 will change the UwndEncPty {CP-264} to match the control output signal based on

the recorded information. For unipolar drives, UwndCOPolarity {CP-282} may also have been

changed based on the recorded information.

If the unwind axis is NOT under CX-1102 control or is Unipolar Brake:

1) Rotate the unwind roll in the forward direction, then in the reverse direction.

2) Observe the value in UwndEncRPM {MP-02} for a sign change. If the sign does not change then check the

encoder input wiring.

Pass test:

The CX-1102 will flash "Uwnd PASS" then "Pg Down" in the bottom center of the display.

Setup State {MP-59} will equal 6.

Press the “Page Down” key to proceed to the next step.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Contrex CX-1102 Bedienungsanleitung Seite 16