Contrex CXB2040 Bedienungsanleitung PDF herunterladen (Seite 11)

CXB1525 and CXB2040 MANUAL

8900 Zachary Lane N., Maple Grove, MN 55369 U.S.A. 8

• Surface mount Constructed with surface mount components.

technology:

• Complete isolation: Complete isolation from input to output.

• Silent operation: Carrier frequency is 20KHz.

• Short circuit protection: Complete short circuit and ground fault protection.

• LED diagnostics: red LED(S) illuminate to display various fault conditions and a green LED

illuminates to indicate normal operating conditions.

• Encoder emulation: Encoder emulation comes standard with line driver outputs,

quadrature and zero index.

• Frequency response 750 Hz minimum.

(Velocity Loop):

• Frequency response 2 KHz minimum.

(Current Loop):

• Dual signal inputs: Two single-ended or one differential. Both single-ended inputs may be use

simultaneously. All inputs have up to 15,000 A/V gain, and all inputs will

accept ±13VDC.

• Dual mode operation: The standard amplifier may be configured for simulated velocity

(RPM) control or current (torque) control.

• Current limit: Maximum motor current is adjustable.

• Digital limit/enable Three separate logic inputs can stop the motor in either or both

Inputs: directions. Inputs may be configured for active-high or

active-low, pull-up or pull-down termination, and a 0 to

+15V or 0 to +5V range.

• Encoder outputs: Incremental (quadrature) position outputs with separate index.

19 different encoder counts, from 125 to 4096

counts/revolution , are available. Differential line-

driver output devices sink and source 40mA.

• Tachometer output: DC output proportional to motor RPM.

• Fault Input/Output: Open-collector output goes low in the event of a fault. This input is

configured so that externally forcing this output low will inhibit amplifier.

This allows all fault outputs in a multi-axis system to be connected together

(wire-ORed) to shut down all amplifiers should any amplifier have a fault.

• Fault input/output: Open-collector output goes low in the event of a fault. This input is

configured so that externally forcing this output low will inhibit amplifier.

This allows all fault outputs in a multi-axis system to be connected together

(wire-ORed) to shut down all amplifiers should any amplifier have a fault.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Keine Kommentare

Contrex CXB2040 Bedienungsanleitung Seite 11