Contrex MLP-Trim Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Sensoren Contrex MLP-Trim herunter. CONTREX MLP-Trim User Manual [en] [es] Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 4
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
MLP-TRIM INSTALLATION/START-UP GUIDE
CAUTION
Hazardous Voltages. Can cause severe injury, death or damage to
equipment. The MLP-Trim should only be installed by a qualified
electrician.
Proper earth grounding of all electronic equipment is required for
successful operation. Connect a low impedance earth ground to
terminal 3 of connector J4.
Separate all logic and signal level wiring (J1, J2, J3, J5 and J6) from all
AC power wiring (J4).
Shield all logic and signal wiring (J1, J2, J3, J5 and J6) and terminate to
earth ground at one point only.
REQUIRED WIRING
CC
CC
C
ONTREX, INC.ONTREX, INC.
ONTREX, INC.ONTREX, INC.
ONTREX, INC.
SK1454 Rev 2SK1454 Rev 2
SK1454 Rev 2SK1454 Rev 2
SK1454 Rev 2
Page 1
Seitenansicht 0
1 2 3 4

Inhaltsverzeichnis

Seite 1 - REQUIRED WIRING

MLP-TRIM INSTALLATION/START-UP GUIDECAUTIONHazardous Voltages. Can cause severe injury, death or damage toequipment. The MLP-Trim should only be inst

Seite 2

SCALINGAfter completing the required wiring of the MLP-Trim, follow the procedure below to scale the MLP-Trim and motordrive for Master format RPM ope

Seite 3 - TROUBLE-SHOOTING

FOLLOWER OPERATIONComplete the “Scaling” and “Tuning” procedures for Master mode (Page 2) before proceeding with Follower operation. To enable Follow

Seite 4

Step 4: Check MP-47 (Speed Command Out).a) Should not be “0” or “100”.b) If “0”, then return to step 1 of “Scaling”.c) If “100”, check wiring to d

Kommentare zu diesen Handbüchern

Keine Kommentare